Simrad NSO-II Manuale di Installazione

ENGLISHNSO-II Marine ProcessorInstallation Manualsimrad-yachting.comNSO-II_IM_EN_988-10392-001.indd A 9/07/2013 3:52:13 p.m.

8 | Wiring | NSO-II Installation ManualWiringFor easier access to connectors, undo the two philips screws visible on the bottom front of the NSO-II ca

| 9Wiring | NSO-II Installation ManualPower Control unconnectedDevice will turn on and off when the power button on the front of the unit is pressed.

10 | Wiring | NSO-II Installation ManualExternal alarmBlue wire on power cable:An external alarm can be connected to one or more NSO-II Processors on

| 11Wiring | NSO-II Installation ManualConnecting displaysUpto two displays may be connected to the NSO-II via the HDMI ports.Currently supported moni

12 | Wiring | NSO-II Installation ManualTouch screen controlThe NSO-II may be controlled solely by touchscreen displays. Support is included to interf

| 13Wiring | NSO-II Installation Manual ¼ Note: Most NMEA 2000 devices can be connected directly to a Simrad SimNet backbone and SimNet devices can be

14 | Wiring | NSO-II Installation ManualNMEA 0183 device connectionThe NSO-II has four serial ports, which are connected to via two discrete cables. E

| 15Wiring | NSO-II Installation ManualIf the number of ethernet devices exceeds the number of available ports on the NEP-2, it is possible to link tw

16 | Wiring | NSO-II Installation ManualCZone connection to NMEA 2000When interfacing to C-ZONE network it is recommended to use a BEP Network interfa

| 17Software setup | NSO-II Installation ManualSoftware setupPower Control setupTo confi gure a display as a Power Control ‘Slave’ or ‘Master’, select

NSO-II_IM_EN_988-10392-001.indd B 9/07/2013 3:52:38 p.m.

18 | Software setup | NSO-II Installation ManualEchosounder software version For external sounder modules, the software version is displayed under So

| 19Software setup | NSO-II Installation ManualRadar setupSetup and confi guration of the Broadband radar has been simplifi ed compared to traditional p

20 | Software setup | NSO-II Installation ManualSidelobe suppressionOccasionally false target returns can occur adjacent to strong target returns such

| 21Software setup | NSO-II Installation ManualSerial port setupNMEA 0183 setup is done from the Network Settings page. Receive waypointSelect this op

22 | Software setup | NSO-II Installation ManualNMEA 2000 / SimNet setupSetup is required on initial start up of the system, or if any part of the net

| 23Software setup | NSO-II Installation ManualDiagnosticsThe NMEA 2000 tab on the diagnostics page can provide information useful for identifying an

24 | Software setup | NSO-II Installation ManualIP addressesThe lower table shows the IP address of the display being viewed (top of list), the Master

| 25Software setup | NSO-II Installation ManualWi setupTo connect to a GoFree device a suitable wifi Android tablet or Apple ipad is required.Naviga

26 | Software setup | NSO-II Installation ManualChannelChannel setting is available in order to overcome potential interference to the GoFree device b

| 27Software setup | NSO-II Installation ManualAutopilot setupVerifying the autopilot connectionWhen an AC12N, AC42N, or SG05 is connected to the NSO-

| 1 | NSO-II Installation ManualPrefaceAs Navico is continuously improving this product, we retain the right to make changes to theproduct at any t

28 | Software setup | NSO-II Installation Manual ¼ Note: Installing a feedback unit will enhance the performance of the autopilot and provide an accur

| 29Software setup | NSO-II Installation ManualSeatrialsA seatrial can only be performed if the dockside settings are completed and confi rmed. The sea

30 | Software setup | NSO-II Installation ManualMagnitude of local fi eld in % of earth’s magnetic fi eld.LUBBER LINEDirection of local fi eld with respe

| 31Software setup | NSO-II Installation ManualHI-A High response parameters set automaticallyLO-A Low response parameters set automaticallyHI-M High

32 | Software setup | NSO-II Installation ManualVMG optimizingYou can optimize the VMG to wind. When selected the function will be active for 5–10 min

| 33Software setup | NSO-II Installation ManualMinimum rudderThis parameter fi lters small rudder commands to prevent high rudder activity.Some boats m

34 | Software setup | NSO-II Installation ManualSetting CZone to display at startupWith this option selected, the CZone control page will be shown fi r

| 35Software setup | NSO-II Installation Manual Software Updates and Screen Calibration From time to time Simrad releases software updates to its exis

36 | Accessory cables | NSO-II Installation ManualAccessory cables NMEA 2000 compliant data cablesPart Number Description000-0124-69 Micro-C start

| 37Supported data | NSO-II Installation ManualSupported dataNMEA 2000 compliant PGN ListNMEA 2000 PGN (receive)59392 ISO Acknowledgement59904 ISO Req

2 | | NSO-II Installation Manualuser is encouraged to try to correct the interference by one or more of the followingmeasures:Reorient or relocate

38 | Supported data | NSO-II Installation Manual129540 GNSS Sats in View129794 AIS Class A Static and Voyage Related Data129801 AIS Addressed Safet

| 39Supported data | NSO-II Installation ManualNMEA 2000 PGN (transmit)61184 Parameter Request/Command65287 Confi gure Temperature INSOcts65289 Trim T

40 | Supported data | NSO-II Installation Manual NMEA 0183 supported sentencesTX / RX GPSReceive GGA GLL GSA GSV VTG ZDATransmit GGA GLL GSA GSV VTG Z

| 41Speci cations | NSO-II Installation Manual Speci cationsMechanical/EnvironmentalCasing ABS plasticOperating temp -15°C to +55°CWater ingress IPx

42 | Dimensioned drawings | NSO-II Installation Manual Dimensioned drawings232 mm (9.14”)281 mm (11.05”)R=2.5 mm (0.1”)R4.2 mm(0.17”)8.0 mm(0.31”)66

NSO-II_IM_EN_988-10392-001.indd 43 9/07/2013 3:54:36 p.m.

*988-10392-001*NSO-II_IM_EN_988-10392-001.indd 44 9/07/2013 3:54:36 p.m.

| 3Contents | NSO-II Installation ManualContents4 NSO-II Overview4 Included Items5 NSO-II Marine Processor Box6 OP40 Controller (not included)7 Hard

4 | NSO-II Overview | NSO-II Installation ManualNSO-II OverviewThe NSO-II Marine Processor features a fast quad core processor, and dual monitor outpu

| 5NSO-II Overview | NSO-II Installation ManualNSO-II Marine Processor Box12345 6789Key Description1 Ethernet Network ports with PoE (2x)2 Ethernet

6 | NSO-II Overview | NSO-II Installation ManualOP40 Controller (not included)MARK VESSELSTBYAUTOPWRMOB12345678910111213141516PLOT GO TOMENU WIN1367PQ

| 7Hardware Installation | NSO-II Installation ManualHardware InstallationMounting locationChoose the mounting locations carefully before you drill or